Can you provide your doveconf -n after adding the database *after* LDAP.
You probably need to add 'noauthenticate' as one parameter after the userdb ones.
Aki
On 07.08.2018 11:05, Simeon Ott wrote:
May you please clarify that? Where should I omit the userdb_ prefix? Which of my attempts are you pointing at? As stated, I omitted the userdb_ prefix when working with an LDAP attribute.
On 7 Aug 2018, at 10:03, Aki Tuomi <aki.tuomi@dovecot.fi> wrote:
with ldap userdb, you need to omit the userdb_ prefix.
Aki
On 07.08.2018 10:54, Simeon Ott wrote:
Sorry for that! I was offline during writing my answer to your mail and so it left my outbox after the advice from Sami.
The solution works well when using passwd userdbs only. I didn’t get it running in conjunction with ldap userdb. I tried to use an LDAP attribute and mapping it to userdb_acl_globals_only and another try with acl_globals_only. Both attributes were not considered by the lookup. Another try was to use a separate passwd-userdb for this attribute only. When placing the passwd-userdb before the ldap-userdb the ldap attributes are not considered. If the ldap-userdb is placed before the passwd-userdb, the extra attribute is not considered. I think this is a wanted behaviour.
Any ideas in conjunction with LDAP?
On 7 Aug 2018, at 08:54, Aki Tuomi <aki.tuomi@dovecot.fi> wrote:
As Sami pointed out, I had wrong syntax:
close, but few typos. userdb should be:
userdb { driver = passwd-file args = username_format=%Lu /etc/dovecot/share.passwd }
Sami