I hear what your saying, but if you read and follow the repo page, it says run update, and then upgrade. Also as a test, I did remove the old 2.2 code, and installed the new 2.3 code, and again authentication fails.
I am sure I may be missing something stupid, but the bottom line is, how can I track down why it will not auth using PAM under the newer code, when even looking at the auth modules, the configs appear to be the same on 2.2 and 2.3, so I didn't see any adjustments I could actually make..
Howard Leadmon PBW Communications, LLC http://www.pbwcomm.com
On 12/27/2017 5:39 PM, Noel Butler wrote:
Why on earth you think you could upgrade versions by using two unrelated and different repo's is beyond me.
This has always been a problem, even back in the 90's with the RPMs, RH v say for example Fresh, because package maintainers will package differently.
Its like trying to stick a cisco 1800 image on an ASR9K and expecting it to work perfectly.
Though we don't use deb or rpm based systems and haven't for about 15 years, if I was to, I think I'd be using the creators version, and not a distro's version.