[Dovecot] Upgraded to Dovecot-1.2.16 and Sieve-1.1.8 but Still No Sieve Parameters

[Jay Welch]

Why do I need to download Dovecot-2.0 to enable sieve? From looking at 
the dovecot website and other howto's Sieve will work with Dovecot-1.*.

On 4/12/2011 7:21 PM, 邓卫华 wrote:
>
>
> you have to download dovecot-2.0-pigeonhole-0.2.2 and install it to
> enable sieve in dovecot.
>
> On Wed, 13 Apr 2011 00:34:11 +0300, Timo
> Sirainen wrote:
>
>> Then it sounds like the Dovecot version you're
> running hasn't been patched with managesieve support. I don't actually
> see you mention how you upgraded, from source or from some binary
> package (and in what OS/distro).
>> Note that with v1.x if you install
> Dovecot + Sieve you do get both of them, but it doesn't automatically
> mean that Managesieve is installed. You need to patch Dovecot for that
> (sieve is not managesieve!)
>> On 13.4.2011, at 0.17, Jay Welch
> wrote:
>>> It is managesieve. protocol managesieve { # Specify an
> alternative address:port the daemon must listen on # (default: *:2000)
> listen = localhost:2000 managesieve_logout_format = bytes ( in=%i :
> out=%o ) } I just did a cut and paste into the conf file. On 4/12/2011
> 2:14 PM, Timo Sirainen wrote:
>>>> On 13.4.2011, at 0.09, Jay Welch
> wrote:
>>>>> Starting Dovecot Imap: Error: Error in configuration
> file /etc/dovecot.conf line 676: Unknown protocol name (section changed
> in /etc/dovecot.conf at line 674)
>>>> Unfortunately it doesn't say here
> what the name is.
>>>>> The protocol on line 674 is the Manageseive
> protocol. Not sure where I am going wrong with this? Any help is much
> appreciated.
>>>> Is it Managesieve or managesieve? The case matters
> here..
>>> -- This message has been scanned for viruses and dangerous
> content by MailScanner, and is believed to be clean.
>

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.