Dovecot-news

dovecot-news@dovecot.org

March 2010

1 participants
2 discussions

v2.0.beta4 released
by Timo Sirainen 22 Mar '10

22 Mar '10

http://dovecot.org/releases/2.0/beta/dovecot-2.0.beta4.tar.gz http://dovecot.org/releases/2.0/beta/dovecot-2.0.beta4.tar.gz.sig I think this release is finally feature complete. There are still some bugs left to be fixed, but it's mainly in the dsync/mdbox area. v2.0.rc1 should hopefully be out in a couple of weeks. After that v2.0.0 will be released after no serious bugs have been found for a couple of weeks. Major changes since beta3: - auth process now runs as $dovecot_internal_user ("dovecot") by default. Auth worker processes still run as root by default, so this won't break PAM etc, but it could break passwd-file configurations. - It can now read v1.2's dovecot.conf file. If you find that it won't read your config, let me know and I'll see about adding code to fix it. It'll log warnings about each obsolete setting it sees. The easiest way to get rid of the warnings is to just translate your old config to v2.0: doveconf -n -c old.conf > new.conf - auth passdb/userdb configuration in example-config is now a bit different .. hopefully less confusing to new people than the old one. - added support for auth settings (including passdb/userdb) inside protocol sections, so it'll affect only those protocols - mail_plugins can now be set more easily. you can have a single global mail_plugins and then add more plugins to it like protocol imap { mail_plugins = $mail_plugins imap_quota } - doveconf finally shows all settings, including all protocol, local and remote sections - doveadm quota get|recalc command added. This is a plugin (yeah, doveadm now supports plugins!), so you must have a global mail_plugins=quota setting for the command to show up. - doveadm kick user/network to kick out logged in users (by sending TERM signal to processes). This was written by Pascal Volk. - and of course tons and tons of fixes all around

1 0

v1.2.11 released
by Timo Sirainen 08 Mar '10

08 Mar '10

http://dovecot.org/releases/1.2/dovecot-1.2.11.tar.gz http://dovecot.org/releases/1.2/dovecot-1.2.11.tar.gz.sig mbox users really should upgrade, because by sending a message with a huge header you could basically cause a DoS (this problem exists only with v1.2.x, not with v1.0 or v1.1). - mbox: Message header reading was unnecessarily slow. Fetching a huge header could have resulted in Dovecot eating a lot of CPU. Also searching messages was much slower than necessary. - mbox, dbox, cydir: Mail root directory was created with 0770 permissions, instead of 0700. - maildir: Reading uidlist could have ended up in an infinite loop. - IMAP IDLE: v1.2.7+ caused extra load by checking changes every 0.5 seconds after a change had occurred in mailbox

1 0